Filter
Top Products
48
1
Reinstall Harness: Fit the
buckle strap down through
the slot in the seat. Make
sure buckle faces out. From
the bottom of seat, pull
buckle's metal clip completely
through pad and shell.
3
WARNING
!
Failure to reattach the harness system
correctly can result in serious injury or death.
Thread the harness down
through slot on left side of
shell (1), across bottom of
seat (2) and up through
slot on right side (3).
Thread one buckle plate
onto harness from back to
front (4).Thread the
harness retainer (5).Do
the same to the other
harness end. Make sure the
harness is not twisted.
Push harness ends through
upper slots in shell (6).
1
2
3
4
5
6
49
5
4
Fit loops on harness ends
onto the splitter plate.
Pull harness through the
back. Make sure the
harness goes OVER the
metal bar, BETWEEN
metal bar and plastic
handle of the
harness/headrest adjuster.
Reinstall Base:
Remove bar from base.
Line up shell with base.
Begin with the rounded
end and push bar
completely through slot
until it locks in place.
Refer to “Removal of Seat
Base” section.
6
2
WARNING
!
Failure to place harness over the metal bar,
between bar and plastic handle of the
harness/headrest adjuster in back, can
result in serious injury or death.
Pull up on buckle to make
sure buckle’s metal plate is
completely through the
pad and shell.
WARNING
!
Failure to place buckle’s metal plate
completely through pad and shell can result
in serious injury or death to the child.
4358-3410D Alpha 5pt 1/26/06 11:39 AM Page 51