Filter
Top Products
Internal All-in-One Card Reader/Writer
5
3 If you want the alternate colored bezel, change it now by pressing the plastic clips on
each side of the card reader with a pen or pencil and pulling the bezel off, then
snapping the new bezel into place.
4 Locate a USB connector on the motherboard and make sure the connector is
compatible with your card reader’s USB connector.
5 Carefully slide your card reader into the empty
3.5" drive bay.
6 Secure your card reader to the drive bay with the four mounting screws (two screws
per side).
Pin Wire color Function
P5 No contact No contact
P4 Black/shield Ground
P3 Green D+
P2 White D-
P1 Red Vbus
Push in
plastic clips
Screw
Screw
DX-CRDRD_10-0881 EN.fm Page 5 Tuesday, August 31, 2010 4:02 PM