Filter
Top Products
10
Battery Operation
In the event that battery power is completely depleted, HardWire pedals
automatically switch into bypass. This eliminates the need to remove the pedal
from your pedal chain if the battery is dead. To replace the battery, do the
following:
1. Using the tip of a 1/4” guitar cable, push one of the Release Pins in on
either side of the Foot Switch, and remove it from the pedal chassis.
2. Remove the battery from the battery compartment and disconnect
the battery cable.
3. Connect a new battery to the battery cable and put it back in the
battery compartment. Make sure the battery cable does not interfere
with the spring or pedal switch arm.
4. Place one hole of the Foot Switch over its corresponding pin.
5. Push the opposite pin in and lower the other side of the Foot Switch