Filter
Top Products
Attach car seat to base.
Recheck recline of car seat. Adjust if necessary (see step 8).
Removal Of Base Installed With LATCH:
Loosen lower anchor belt:
- While pressing down in center of base to reduce tension on lower anchorage belt,
push adjuster release button and loosen belt.
Press and hold the connector retainer spring .
Push connector in, then rotate connector , and pull out to unhook from the
vehicle anchorage (fig. a). If the connector can’t be rotated, push in and lift the
connector to unhook from the vehicle anchorage.
Repeat to remove connector on opposite side.
25
(fig. a)
13
14
1
2
3
1
2
3
1
2
3
Storage Of Lower Anchorage Belt And Lower Anchor Connectors:
When not using the LATCH System, store the anchor belt adjuster and lower anchor
connectors by placing the connectors over the pins inside base and folding belts into
therecessedareasofthebase(fig. a).
- Belts and lower anchor connectors MUST be properly stored in base to allow
secure attachment of car seat to base.
26
(fig. a)
Pins
LATCH Lower
Anchor Connector