Filter
Top Products
Refer to vehicle owner’s manual to identify the seating locations with LATCH System. Select
the seating location to be used and locate the vehicle lower anchorages at the seat bight.
A LATCH Anchorage System with 280 mm (11 inch) spacing may not be available in
your vehicle in the rear center seating position. If use of the rear center position is
preferred, use the vehicle seat belt to secure the car seat. See “Securing Base
With Vehicle Seat Belt” section.
21
Securing Base With LATCH System:
• Only use the car seat LATCH System in vehicle seating locations recommended by the
vehicle m anufacturer for use with LATCH and that have an anchor spacing of 280 mm (11 inches).
• LATCH connectors must be secured to the vehicle LATCH anchorages only. Connection to
other vehicle components could result in the anchor tearing free in a crash.
• Never attach more than one anchor connector to a vehicle lower anchorage unless
recommended by the vehicle owner’s manual for that vehicle.
WARNING
DEATH or SERIOUS INJURY can occur
1
22
If vehicle seat back is adjustable, adjust vehicle seat back into
most upright position.
Remove car seat from base.
Lift the LATCH lower anchor connectors out of the base (fig. a).
Lengthen lower anchor belt. While pressing adjuster release button,
pull belt to extend the length of lower anchor belt (fig. b).
Place lower anchor belt over side of base and into
belt slot in vehicle lap belt guide with the belt adjuster
slide buttons facing away from the car seat (fig. c).
If the adjuster is not in that position, turn the belt and
adjuster over.
Repeat for opposite side.
Check that the belts are not twisted.
3
4
5
7
2
(fig. a)
(fig. c)
(fig. b)
Vehicle Lap
Belt Slot
LATCH Lower
Anchor Connectors
Lower
Anchor
Belt
Adjuster
Release
Button
Pull
6