Filter
Top Products
SKU 03882 For technical questions, please call 1-800-444-3353. PAGE 6
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly
Diagram (page 16).
Permanent Mounting Of The Winch:
1. Select a mounting site on the bed of a truck, trailer, or other suitable location.
CAUTION: This Winch can generate 9,500 pounds rolling, 8,500 pounds
marine, and 3,000 pounds pulling force. Make sure the location selected
can withstand this much force. It may be required to use steel reinforce-
ment plates (not included), and/or to weld on additional bracing (not in-
cluded), depending on the desired mounting location.
2. Align the Base of the Winch with the desired location, and mark for drilling the
three
mounting holes required to attach the Winch to the desired location. Then,
drill these three mounting holes on the vehicle/trailer. (See Figure A.)
3. Use three hardened Steel Bolts at least 3/8” in diameter, three Lock Washers,
and three Nuts (all not included), to securely attach the Winch to the desired
location. (See Figure A.)
BOTTOM VIEW
SIDE VIEW
MOUNTING HOLE (3/8”)
MOUNTING HOLE (3/8”)
MOUNTING HOLE (3/8”)
BASE OF WINCH
3/8” BOLT
(NOT INCLUDED)
LOCK WASHER
(NOT INCLUDED)
NUT
(NOT INCLUDED)
MOUNTING
SURFACE
FIGURE A