Filter
Top Products
18
2.3.2 Fixing the hitch arm with Chariot axle hitch on the bicycle
Parts supplied:
Aluminium coupling for attachment on
the rear axle; quick release skewer
Close the Q.R. lever with the end of the
lever pointing upwards. In this position
there is enough space to insert the
securing pin. Please read also the sec-
tion "Jogging Kit”, which contains furt-
her instructions on how to correctly
operate a Q.R. lever.
Fitting the hitch on a bicycle with quick
release axle on the rear wheel
Remove the existing quick release ske-
wer. Loosen the nut of the Chariot
quick release.
Push the Q.R. axle through the hitch
and then through the hollow axle of the
bicycle’s rear wheel. The opening for
the hitch ball must point forward.
Screw on the Q.R. nut on the other
side of the Q.R. axle. Both Q.R. springs
must be located on the Q.R. axle
in such a way that the narrower side of
the spring points towards the centre of
the rear wheel hub.
Fitting the hitch cups on a bicycle with
solid rear axle (e.g. all bicycles with
hub gearing)
Remove the existing nut and washer on
the left hand side of the wheel axle.
Place the aluminium hitch cup with its
opening pointing forward on the wheel
axle and screw on the axle nut.
Depending on the hub type, the exi-
sting washer needs to stay on the
frame (for fitting the hub, as well as tor-
que values for fastening the axle nut,
see manufacturer’s instructions).
Safety Recommendation:
The axle nut must be tightened on the axle thread by at least 5 full turns, so that an adequate clamping force is ensured. A
thread which is too short can lead to accidental loosening of the rear wheel and thereby to damage and accidents.
If in doubt ask your specialist dealer!
Detaching the coupling
Depress the securing pin of the Q.R.
lever, open the lever, push the axle
upwards and remove the coupling
downwards. Remove the safety strap.