Filter
Top Products
12
12
JOGGING CTS KIT
JOGGING CTS KIT
3.0 Installation
Remove any other conversion kits from the
wheel wheel arm attachment bracket. Insert
the wheel arms by pressing the small button
and sliding the arm into the wheel arm
attachment bracket. The large button should
engage into the hole on the wheel arm
attachment bracket.
Slide the wheel axle all the way into the
wheel bracket dropouts.
With the quick release lever opened 90
o
to
the wheel brackets (ie. pointing straight
out), hand-tighten the nut on the back side
of the quick release skewer.
adjusted, you will feel resistance halfway
through tightening the lever. Make sure the
lever is closed towards the back of the
carrier.
Install the quick release axle through the
wheel’s hollow axle with a spring on each
side of the wheel. Screw the nut onto the
other side of the skewer axle.
WARNING:
Failure to properly attach wheels could
cause the wheels to fall off, resulting in
an accident and serious injury.
Overloading the carrier with more than
2.2lb (1kg) in the rear storage pouches
can make the carrier unstable.
The following safety precautions should
be followed otherwise injury or death to
you or to your passengers could result:
– Use wrist safety straps at all times.
– Always use seat belts.
– Always use parking brake when
stroller is stationary.
– Never in-line skate with the jogging kit.
– Never climb or descend stairs with
the jogging kit.
– Use extreme caution on hills.
WHEEL ARM
WHEEL
BRACKET
QUICK RELEASE LEVER
There are 3 straps attached to the outside
of the storage compartment that you can
use to attach the front wheel of your jogger
to in the event you have purchased both a
Cycling kit and Jogging kit but wish to keep
the Jogging kit components with the carrier.
The wheel arms can be placed inside the
storage compartment.
3.1 Storage
Close the
quick release
lever by push-
ing it flat
against the
wheel brack-
et. When the
nut is properly