Filter
Top Products
To open stroller:
• Stand stroller upright and
pull out on Red Frame
Latch while opening.
• Spread handle and rear
legs until both Fold Locks
“click” into position.
ASSEMBLY
3
Opening Stroller
WARNING
Prevent a possible choking hazard, discard
axle protectors and polybag which contained
rear wheel parts.
To attach rear axle and brakes:
• Remove axle protectors from
ends of axle and discard.
• With stroller laying face
down on floor, slide brake
lever brackets onto rear legs
until they “click” in place.
NOTE: Brake levers must face
rear of stroller.
To attach wheels to rear axle:
• Slide Wheel onto end of Axle with brake ribs facing in.
• Push Wheel Retainer onto end of Axle. Make sure large
end of Wheel Retainer is towards Wheel. Wheel Retainer
should snap into groove on end of Axle.
• Snap wheel Retainer Cap over Wheel Retainer.
• Line up slot in Hub Cap with rib on Wheel and snap
Hub Cap in place.
Rear Axle and Wheels
CAUTION:
• Failure to install retainer cap may cause wheels to come
off of stroller.
• After wheel assembly is complete, pull on wheels to
check that they are locked into place.
Hub
Cap
Retainer
Cap
Wheel
Retainer
Wheel
Axle
Fold
Locks
Red Frame
Latch