Filter
Top Products
VEHICLE SEAT BELTS continued
Locking Clip
(top back of
car seat)
Latch Plate
❃ Continuous Loop Combination
Lap/Shoulder Belt with Sliding
Latch Plate
Pull on latch plate. If belt
slides freely through latch
plate, a locking clip
must
be
used (stored on top back of
car seat).
WARNING
Failure to use locking clip where required will
result in car seat not being securely held in place
and child being seriously injured or killed in a
sudden stop or accident.
1 Place car seat in seating position to be used.
2 Thread vehicle seat belt through openings in car seat
and tighten lap belt.
3 With vehicle lap belt properly tightened,
hold the combination lap/shoulder belts
together just behind the sliding latch
plate, and unbuckle belt.
4 Continue holding vehicle seat
belts together and slide locking
clip on vehicle seat belt
approximately 1 cm
(1/2 inch) away from latch
plate.
5 Rebuckle vehicle seat belt. HINT: It may be
necessary to press car seat into vehicle cushion in
order to rebuckle.
Test installation again to see if car seat is secure. If
it is not, remove locking clip, adjust vehicle seat belt
and re-attach locking clip.
WARNING
Remove locking clip from vehicle seat belt when
not being used with a car seat. The vehicle seat
belt will not properly restrain an adult or child and
serious injury could occur. Do not use locking
clip as a vehicle seat belt shortener.
21
Pull
1 cm (1/2")
Locking
Clip
Latch
Plate