Filter
Top Products
Adjust car seat to recline position and place
rear-facing on vehicle seat. DO NOT use any
other recline position when using rear-facing.
Thread vehicle seat belt through opening and
buckle belt.
Press down firmly in center of car seat to
compress vehicle seat cushion while tightening
vehicle seat belt (fig. a).
Pull front to back and left to right to check for
secure installation (fig. b). Vehicle lap belt
MUST stay tight.
If not secure, see “Vehicle Seat Belts” section.
Position level adjuster until entire ball is in
green zone (fig. c). This may require removal
of vehicle seat belt and re-installation following
steps 1 through 4. Then re-check level
indicator.
NOTE: Vehicle must be on
level ground and child in
car seat when using level
indicator.
REAR-FACING INSTALLATION
1
3
4
5
2
6
(fig. a) (fig. b) (fig. c)
Opening