Century PM-1109AB Baby Carrier User Manual


 
4
ASSEMBLY continued
WARNING
Prevent a possible choking hazard, discard
axle protectors and polybag which contained
rear wheel parts.
CAUTION:
Failure to install retainer cap may cause wheels to come
off of stroller.
After wheel assembly is complete, pull on wheels to check
that they are locked into place.
Hub
Cap
Retainer
Cap
Wheel
Retainer
Wheel
Connector
Brake
Lever
Bracket
Snap one end of cup holder
over stroller frame above
canopy, rotate down to
opposite side and snap in
place.
Snap both straps of storage
pouch over stroller handle
as shown.
Attaching Cup Holder and Storage Pouch
Ribs
Axle
WARNING
• To avoid burns, never put hot liquids in cup
holder.
• Avoid possible tipping. DO NOT place more
than 3 lbs. (1.4 kg) in cup holder and
storage pouch combined.
3 Secure Wheel to Axle as shown:
Push Connector onto Axle with Ribs facing in.
Slide Wheel onto Axle and push into Connector.
Slide Wheel Retainer onto end of Axle. Make sure large
end of Wheel Retainer is towards Wheel. Wheel Retainer
should snap into groove on end of Axle.
Snap wheel Retainer Cap over Wheel Retainer.
Line up Hub Cap tabs with slots in Wheel and snap Hub
Cap in place.
1 Twist both handle locks inwards
until loose.
2 Grasp center of handle and pull
out to desired length.
3 Twist both handle locks outwards
until they are tight.
DO NOT over tighten handle
locks.
Adjusting Handle