Filter
Top Products
EN-28
Configuring Settings with the Keyboard
■ Tones
Parameter List
Parameter Settings
Operation
Type
(page
EN-26)
Description Remarks
bp
Reverb
(REVERB)
Off (OFF), 1 to 4
Default: 2
A Specifies the reverb of notes.
(page EN-12)
bq
Tone selection See page EN-9.
Default: GRAND
PIANO
(CONCERT)
A Assigns a tone to the keyboard.
(page EN-9)
br
Chorus
(CHORUS)
Off (OFF), 1 to 4
Default: Off
D Controls the breadth of notes.
(page EN-12)
bt
Brilliance
(BRILLIANCE)
–3 to 0 to 3
Default: 0
B Specifies the brilliance of notes.
Pressing [+] makes notes brighter
and harder. Pressing [–] makes
notes mellower and softer.
• To return the setting to its initial default (0),
press [+] and [–] at the same time.
cn
Layer balance –24 to 0 to 24
Default: –10
B Specifies the volume balance
between the main tone and the
layered tone. (page EN-11)
• To return the setting to its initial default
(–10), press [+] and [–] at the same time.
cq
Duet pan Off (OFF), On (ON)
Default: Off
D When turned on, outputs the left
side keyboard tone from the left
speaker and the right side
keyboard tone from the right
speaker while duet is turned on.
(page EN-15)
• Supported only when a piano tone is being
used. Reverb is not applied when this
parameter is turned on.
cr
Bass damper
effect
Off (OFF), On (ON)
Default: Off
D When turned on and the BASS
(LOWER) tone is selected, pressing
the damper pedal or sostenuto
pedal will apply sustained
reverberation to the BASS
(LOWER) tone. (page EN-10)
cs
Damper noise Off (OFF), On (ON)
Default: On
D Enables/disables damper noise
output. (page EN-13)
PX760-ES-1A.indd 30 2014/06/24 10:35:15