Filter
Top Products
5
Burley Walk ‘n Roller Manual; models 2003 and earlier
Replace the roll bar into the
new hinge. Use the pre-existing
1.5 inch hex bolt from the old
hinge and the new jam locking
nut provided. Tighten until
the end of the bolt is fl ush or
slightly protrudes beyond the
nut.
On the right side, remove the old
catch from the frame saving the
Phillips head bolt. Install the new
catch using the existing Phillips
head bolt and new standard nut
provided. Tighten securely.
Locate the pair of handle receiver
mounting holes on the bottom of
both the hinge and catch (See 1 and
2 on diagram to the left).
Carefully punch or cut a hole
through the trailer fabric, small
enough to allow a bolt to pass
through to the mounting holes.
(This can be done with the No. 2 Phillips driver.) The fabric is rip resistant to prevent
the hole from growing
1
2
Check that the new roll bar catch and hinge parts and the
roll bar is properly installed. Check the attachment points for
loose elements. Failure to do so could result in serious injury.