Filter
Top Products
IX. Maintenance
Grease the wheel-pivot assembly twice a year (monthly under
wet, dirty, salty conditions). Use a standard grease gun with multi-
purpose (thick brown, or green) grease and insert into the hole on
pivot casing (1). Wipe clean all the old grease that fl ushes out. This
can be done by your local bike shop or gas station while you wait.
Inspect handle, receivers, parking brake and wheel pivot monthly.
Replace any loose or damaged parts.
Burley Walk n’ Roller Limited Warranty
Burley will repair or replace any Walk n’ Roller parts it determines to be
defective for the life of the trailer. The owner of a Burley trailer with Walk n’
Roller parts installed must present the trailer for repair at an authorized Burley
dealer, together with an original sales receipt or similar proof of purchase.
This warranty applies to the original owner and is non-transferable. Burley
cannot be responsible for failure due to improper assembly, modifi cation
of parts or instructions, neglect, abuse, accident, and/or normal wear.
The warranty does not cover any trailers used for rental, competition, or
commercial use, nor does it cover Walk n’ Roller parts used on anything
other than a Burley trailer.
Burley neither assumes nor authorizes any person to assume any other
liability in connection with Burley trailers, and there are no oral agreements
or warranties collateral to or affecting this agreement.
This warranty gives you specifi c legal rights. You may also have other rights
which vary from state to state.
Burley Design Cooperative
4020 Stewart Road • Eugene, Oregon 97402 USA
(541) 687-1644 • Fax (541) 687-0436
www.burley.com
Copyright © 2004 by Burley Design Cooperative
“Burley” is a registered trademark of Burley Design Cooperative
Burley d’Lite is a trademark of Burley Design Cooperative
Burley Encore is a trademark of Burley Design Cooperative
Burley Lite is a trademark of Burley Design Cooperative
rev: 10/04
1