Filter
Top Products
10
Operating Instructions
11
Operating Instructions
To Remove Arm Bar, release and remove each
attachment clip, located under armrests (fig. A).
IMPORTANT: If removing for use without
arm bar, replace attachment clips.
Attachment Clip
A
To Install Arm Bar, release and remove each
attachment clip, located under stroller
armrests. Slide arm bar into slots on stroller
armrest, then replace attachment clips (fig. B).
1
If arm bar is installed, remove zippered
cover. If arm bar is not installed, Install arm
bar with smooth side up (fig. C).
B
C
Arm Bar
Attachment
Hooks
D
3
Lower backrest into full recline position
(pg. 8).
4
Place carrier rear facing in stroller, with
attachment hooks aligned with arm bar
(fig. D).
Arm Bar
E
F
Carrier Attachment (cont.)
Carrier Removal
Carrier Attachment
4
Press carrier onto arm bar until clicks are
heard, which confirms attachment (fig. E).
5 Check installation by lifting carrier from rear
to verify that both attachment hooks are
engaged with the arm bar (fig F).
H
1
Fully recline stroller backrest (pg. 8).
2
Squeeze release lever on restraint, while
lifting restraint from stroller (fig. H).
3
If desired, reinstall zippered cover on arm bar.
G
6 Raise stroller backrest to fully secure carrier.
To raise backrest, push backrest up until in
one of four available positions (fig. G).
P251400_R01e.qxd 11/29/2004 3:24 PM Page 12