Filter
Top Products
30
31
Child Seat Functions Child Seat Functions
Storing the LATCH Connectors
When the LATCH connectors are not in use, lift
the child seat cover to access LATCH storage
slots (Fig. A). Fold each end of the LATCH
strap and slide each LATCH connector into the
adjacent slots.
NOTE: Child seats are shipped from Britax with
LATCH connectors in the storage slots.
Recline Adjustment
Pull the recline handle then slide the child seat
shell into the desired position. (Fig. B) Release
the recline handle and verify the child seat has
locked into position.
NOTE: It will be necessary to loosen the tether,
vehicle seat belt, and/or LATCH strap before
adjusting the recline position. The tether, vehicle
seat belt, and/or LATCH strap must be properly re-
tightened after adjusting the recline position.
Chest Clip
Fastening the Chest Clip
Fasten the chest clip by pushing the two halves
together until a positive click is heard (Fig. C).
Releasing the Chest Clip
Squeeze the middle tab together and pull apart
the two pieces (Fig. D).
Adjusting the Chest Clip
Slide chest clip up or down on harness so it is positioned at the
middle of the child’s chest, level with the child’s armpits.
Harness Buckle
Fastening the Harness Buckle
Hold the harness buckle with one hand. Use
the other hand to insert one buckle tongue at a
time into the harness buckle (Fig. E).
Proper connection is confirmed with a positive
click after inserting each buckle tongue.
Releasing the Harness Buckle
Brace the rear of the harness buckle with one
hand. Press the release button and slide both
tongues to remove from the buckle (Fig. F).
IMPORTANT: Periodically clean the harness buckle
to ensure safe operation. See page 37.
A
x 2
E
C
B
F
D