Filter
Top Products
18
19
If stored, remove LATCH connectors from
storage slots under cover. See page 30. Pull
both connectors completely through the child
seat’s right-side, rear-facing belt slot (Fig. B) so
they are on the outside of the shell.
Press each LATCH adjuster release button and
pull each LATCH adjuster strap to full length.
Thread the LATCH connectors through
forward-facing belt path (Fig. C) to the back
of the child seat.
NOTE: It may be necessary to switch LATCH connectors as
shown on page 29 if ANY of the following conditions exist:
LATCH connector is not in an upright position as
shown in figure D.
LATCH strap is twisted.
A positive click is NOT heard when LATCH connector
and LATCH anchor are connected.
NOTE: If a positive click is not heard, but the LATCH connector is in an
upright position, you should not switch the LATCH connector. The strap may
be too tight or twisted, or there may be debris in the LATCH connector.
1
2
3
•
•
•
Installation: Forward-Facing Installation: Forward-Facing
LATCH Installation
Figure A illustrates a typical forward-facing LATCH
installation.
Verify that your vehicle is equipped with LATCH
anchors. If LATCH anchors are not available, you must
use vehicle belt installation methods.
•
•
Place the child seat sideways on the vehicle
seat, with the back facing you.
Child seat may be in upright or recline position. See
Recline Adjustment on page 30.
Remove the Versa-Tether
®
from pouch and
place up and over the child seat back.
Verify that the LATCH strap is not twisted and
attach the closest LATCH connector to the vehicle
seat back to the farthest LATCH anchor (Fig. E).
A positive click confirms attachment.
Rotate the child seat into the forward-facing
position.
Verify that the LATCH strap is not twisted and
attach the remaining LATCH connector to the
adjacent LATCH anchor (Fig. F).
A positive click confirms attachment.
Push the child seat into the vehicle seat while
pulling each LATCH adjuster strap tight (Fig. G).
Attach the Versa-Tether
®
hook to an approved
tether anchor. Remove all slack from the tether
to secure. Store excess webbing in the tether
pouch. See pages 25 – 28.
Verify all connections are secure and that the child seat is secure.
The child seat is secure when it cannot be moved front-to-back or side-to-
side more than 1 inch (2.5 cm.) at the belt path.
Removal
Disconnect the Versa-Tether
®
from the tether anchor.
Release each LATCH harness from the LATCH anchor by pressing
the red release button on the LATCH connector.
When not in use, always store the LATCH connectors in storage
slots. See page 30.
4
•
5
6
•
7
8
•
9
10
11
•
•
•
•
Forward-Facing
A
B
E
C
G
WARNING!
This child seat must not
be used forward-facing for children less
than one year of age OR weighing less than
20 pounds.
D
Top
Release
Button
F