Filter
Top Products
26
27
OR
a
OR
b
c
WARNING!
Only use the tether connector strap for
rear-facing tether installation when there is NOT a designated vehicle
tether anchor.
d
Using the Versa-Tether
Consult your vehicle owner’s manual for 1
designated tether anchorage locations.
Locate the tether on the rear of the child 2
seat and remove the tether from the pouch.
Place the tether up and over the child seat 3
back.
Install the child seat using the LATCH 4
system or the vehicle belts according to the
instructions in this manual.
Tilt the tether release tab then pull to fully 5
extend the tether strap into a “V” shape.
Locate the hook on the tether strap and 6
attach the tether hook to the vehicle’s
designated tether anchor.
See figure A for a forward-facing installation.•
See figures B and C for a rear-facing •
installation.
IMPORTANT: The tether should be hooked over,
not under, the vehicle tether anchor.
Pull the tether adjuster strap to remove all 7
slack. Roll up excess webbing and store in
tether pouch.
Verify there is tension in the tether strap and 8
that child seat is properly secured.
The child seat is secure when it cannot be •
moved front-to-back or
side-to-side more than 1 in. (2.5 cm) at the belt path.
Tether Connector Strap
NOTE: Britax child seats are shipped with the tether connector strap
attached to the Versa-Tether
®
hook. When not in use with rear-facing
installations that have designated tether anchors or forward-facing
installations, store the tether connector strap in the tether pouch.
Because every vehicle model is different,
sometimes you cannot find a location to
properly anchor the tether. Use the tether
connector strap to assist in creating an
anchor point (Fig. D).
Find a fixed vehicle anchor point that is 1
bolted to the floor.
If you cannot find an acceptable 2
location to create an anchor point,
contact the vehicle manufacturer to
identify a suitable tether connection
point.
Route the tether connector strap around 3
the fixed vehicle anchor point.
Take the metal D-ring and thread it 4
through the webbing loop on the other
end of the tether connector strap.
Pull the metal D-ring all the way through 5
until the tether connector strap is tight
around the metal anchor.
Use the D-ring as an attachment point 6
for hook on tether strap.
Installation: Versa-Tether
®
Installation: Versa-Tether
®