Filter
Top Products
1.0/0309/TG
STEP 4: See PICTURES 4A and 4B. Insert the CANOPY POLE (H) through the hole on the TOP RING (A)
and push it down until it rests in the hole on the BOTTOM RING (F). Insert the two free ends of the METAL
CANOPY FRAME (I) into the top of the CANOPY POLE (H). You may need to gently tap on the canopy frame
with a hammer so that the ends are pushed down into the pole as far as possible (see PICTURE 4B).
Starting by the canopy pole, wrap the FABRIC SKIRT (J) around the BOTTOM RING (F) pressing the grip
tape together. When you get back to where you started, press the grip tape on the two ends of the skirt together.
Put the FABRIC SHEET (K) on the MATTRESS PAD (L) and place the sheet and pad into the crib.
STEP 5: See PICTURE 5. Position the FABRIC CANOPY (M) over the METAL CANOPY FRAME (I).
Secure the grip tape tabs on the fabric canopy around the metal frame. Adjust the canopy so it drapes around the
crib.
Page 4 of 4
PICTURE 4A
H
I
PICTURE 4B
J
K, L
PICTURE 5
M
CARE INSTRUCTIONS:
Wipe crib parts and vinyl pad clean with a damp cloth and mild detergent as needed.
Fabric is poly/cotton. For longevity of the product we recommend hand washing the
bedding; however it can be machine washed cold on gentle and air dried or tumble
dried on low or no heat. Iron on the lowest setting for poly/cotton.
H
I
Your fabric color/pattern
may vary from shown.