Filter
Top Products
Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
Copyright © 2007 - 2009, Baby Trend Inc., All Rights Reserved.
ASSEMBLY ASSEMBLY
5
6
3. To operate the brakes on the Wheels, press
downward on the brake levers. To release, lift
upward on the lever (Fig. 4)
4. Once all four (4) top rails are locked in place,
push down on the center handle (Fig. 5). The
center mechanism will rotate clockwise 90
degrees and automatically lock in place.
IMPORTANT: Test each top rail by pushing
down slightly to conrm each is rigid and
locked securely in place before use (Fig. 6).
ATTENTION:
To use as a bassinet, skip to page 8 for bassinet
installation instructions.
5. Place the Mattress on the oor of the Playard
with the padded side facing up (Fig. 7)
6. Feed the three (3) hook and loop straps located
on the underside of the Mattress through the
slots in the oor of each end of the Playard
(Fig. 8). Fasten the hook and loop straps to the
underside of the Playard oor to prevent the
Mattress from moving (Fig. 9).
FOLDING PLAYARD
1. Undo the three (3) hooks and loop straps
holding the Mattress from underneath the
Playard oor or remove the Mattress for the
Bassinet and set aside.
2. Grasp the center handle, push down and rotate
the handle counter-clockwise 90 degrees and
lift upward until the handle is as high as the top
rails (Fig. 10). Gather the Legs and Wheels
together towards the center as close as possible
so that they nearly touch (Fig. 11).
NOTE: The top rails of the Playard are sill in
the “Locked” position.
3. Locate the rail release lever in the center and
bottom side of each rail. Lift slightly while
squeezing the lever until the rail “Clicks” and
releases. Push down each side of the rail while
still holding the release lever until both sides
are down. Repeat for all remaining sides
(Fig. 12).
NOTE: If the top rail(s) do not release
completely, DO NOT FORCE! Check the
oor of the Playard to make sure all the bottom
rails are unlocked and make sure the middle
handle is pulled up and has not fallen back
down. If so, repeat step #3.
4. Gather four (4) corners and center all together
tightly (Fig. 13).
5. Wrap Mattress around Playard frame with
padded side facing inward.
6. Secure the three (3) hook and loop straps by
feeding them through the loops on the end
of the Mattress and folding them back onto
themselves (Fig. 14).
7. Place folded Playard into carry bag so that the
handle comes through the opening between
each side of the zipper.
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Rotate before
lifting
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14