Filter
Top Products
1. Locate a LATCH seating position as identied in your vehicle
owner’s manual. Some LATCH seating positions may require
deploying of anchors, or installation of guides.
2. Remove the Safety Seat from the base by squeezing the base
release handle located under the center of the foot end of the
Safety Seat and lifting upward on the Safety Seat. (Fig. 25-1)
3. Remove the
LATCH
connectors from
their storage position inside the base
(Fig. 44-1). Place the Base in the rear-
facing position in a forward facing vehicle
seat as shown in Fig. 45-1. The Child
must face the rear of the vehicle and
Safety Seat must be placed in a vehicle
seat that faces forward.
4. Locate the
LATCH
anchors in the vehicle
seat. (Fig. 44-2) Once located, snap the
Safety Seat
LATCH
connectors onto the
steel rod. Listen for the click and check
that both connectors are rmly attached to
the anchor rods by pulling outward on the
connectors. (Fig. 45-2)
5. Proper installation of the Base requires
that the
LATCH
webbing be very tight.
To tighten the webbing, push down hard
with your knee or hand on the Base while
pulling upward on each webbing end.
The webbing will automatically lock in
4544
7.0 INSTALLATION
Fig. 44-1
Fig. 44-2
Latch Anchor
7.0 INSTALLATION
place. Check that there is no slack in the
webbing on both sides of the base and
that the base is tightly installed. Fig. 45-2
and 45-3.
6.
Check that nothing is on top of the base or
anything that will interfere with the proper
latching of the Safety Seat to the Base. Place
the Safety Seat onto the Base and push down
until the Safety Seat latches securely to the
Base and you hear a click. Pull upward on
the Safety Seat to check that the Safety Seat
is securely latched onto the base. (Fig. 25-1)
If the Safety Seat does not securely latch
onto the Base, the Safety Seat will provide
No Protection for your child. DO NOT use
the Safety Seat with the Base if it does not
securely latch onto the Base. Please call
Baby Trend at 1-800-328-7363 for assistance.
7. To remove the base from the vehicle,
squeeze the webbing release button
on the LATCH connector to loosen the
webbing. (Fig. 46-1a) Please note
that the LATCH connector can not be
released from the LATCH anchor if the
webbing is tight. Press the LATCH
hook release button on each
connector to release the connector
from the anchor. (Fig. 46-1b)
Fig. 45-1
Fig. 45-2
Fig. 45-3
Snap onto anchors