Filter
Top Products
• The front fender is secured to the frame by the 5 screws provided.
Examine the bottom of the front fender. You will notice four
1
/4 inch
diameter plastic tubes protruding from the bottom. See figure 7a. These
tubes must be lined up with the holes in the front frame assembly. See
figure 7b. Line up the front fender and press onto the front frame
assembly. See figure 7c. Insert the 5 screws through the underside of
the front frame assembly into the front fender's plastic tubes. Tighten the
screws only until snug. See figure 7d. Do Not over-tighten.
• Lean the stroller forward to rest on the front wheel. To attach the rear
wheels, push each wheel's axle into the plastic corner fitting as shown in
figure 8. Lift upward on the plastic lever on the inside of the corner fitting
as you push the axle into corner fitting. When the wheel will not go on
any farther, release the lever. Check that the wheel has locked into the
corner fitting by pulling on the wheel. If not locked, lift upward on the
lever, push the wheel on farther and release lever.
Ensure that the wheels are firmly locked into place. Do Not use the stroller
if the wheels are not locked into place, but rather contact our customer
service department immediately at (800) 328-7363, between the hours of
8:00am and 4:30pm PCT, for assistance
• To attach the parent tray, position the parent tray in the center of the
stroller handle. Snap the upper portion of the tray over the handle as
shown in figure 9A. Attach the lower portion of the parent tray to the
cross tube, with the screws provided, as shown in figure 9B.
WARNING: Do not place hot liquids
or more than 3 pounds in the parent tray.
Serious burns or unstable conditions could
result.
• To open the canopy, push forward on the front edge of the canopy. Please
see figure 10. Push downward on the tensioners to secure
• To fold the canopy, pull upwards on the tensioners and then pull
backwards on the front edge. Please see figure 11.
The canopy must be in the closed position before folding the stroller.
• The canopy comes with a speaker sewn into a mp3 storage pocket on
the side of the canopy. The speaker has a wire with a male jack for use
with mp3 player so you and your child can listen to music while you jog.
Connect male end of speaker wire into your mp3 player. See figure 11a.
Your stroller is now ready to use
Figure 6.
Figure 7a.
Figure 7b.
Figure 7c.
Figure 7d.
Figure 8.
Figure 9A.
4
Open
Close
Figure 9B.
Insert Screws