Filter
Top Products
• Remove stroller from box. The front wheel, rear wheels, fender, and parent
tray need to be installed prior to use.
• To attach the front wheel, unfold stroller as described in the section
following. See figure 1.
Lean the stroller backwards so that it rests on the handle and rear axle frame
and the front wheel forks are pointing upward.
The front wheel features a quick release attachment system. See figure 3.
Slide the front wheel onto the front forks. See figure 2. The quick release
must be loose enough for the wheel to slide on and the brake release lever
must be in the open position (see figure 6). Line up the tab on the Holding
Plate with the slot on the fork plate. With the wheel in position, tighten the
finger nut on the axle until it is very close to contacting the fork. See figure
4. Rotate the lever to the closed position as shown in figure 5. You should
feel significant resistance when closing the lever and the wheel should be
held tightly. If you do not, open the lever and tighten the finger nut a bit
more and close the lever again. Continue to do this until the wheel is held
tightly in the fork.
Close the brake release lever by rotating it toward the front of the stroller.
See figure 6.
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW THESE INSTRUCTIONS
CAREFULLY. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Ring
Figure 1.
Figure 2.
Figure 3.
3
Front Wheel
Rear Wheels
Fender Screws
Parent Tray
Fender
Figure 4.
Open
Close
Figure 5.
Stroller
TO ASSEMBLE JOGGING STROLLER
PARTS
Parent Tray Screws