Filter
Top Products
ADJUSTING THE HOSE BALL STOP
The hose ball stop determines the length of hose that remains outside of reel. To adjust, pull hose out
past desired position of hose ball stop and latch reel. Loosen both bolts and move ball stop to proper
position. Tighten bolts.
Operating Hose Reel
1. Slowly pull hose from reel to desired length. A ratcheting mechanism inside reel makes a short series
of clicking sounds every half revolution of reel.
2. To lock reel in position, listen for clicking sounds as hose is slowly pulled from reel. When reel clicks,
stop pulling hose. Decrease tension on hose and reel should lock in position.
3. To retract hose onto reel, slowly pull out hose until series of clicking sounds stops (1/8 revolution).
DO NOT LET GO OF HOSE!
4. Allow hose to retract slowly until hose ball stop rests against the hose guide.
5. Periodically check the hose for excessive wear and hose connections for air leaks.
ADJUSTING RECOIL TENSION
1. Disconnect incoming air supply.
2. Pull out about 2 feet of hose and latch the reel.
3. Remove hose ball stop
4. While firmly holding onto edge of reel drum, unlatch reel and carefully allow drum to slowly rewind,
drawing hose end back through guide arm roller assembly and onto reel. Latch reel in position.
5. To Increase Tension: Unlatch reel and turn clockwise (as viewed from air inlet side).
To Decrease Tension: Unlatch and allow reel to rotate slowly counterclockwise (as viewed from air
inlet side).
6. Once desired spring tension is reached, latch reel in position. Feed hose end through roller assembly
in guide arm and reattach hose ball stop.
7. Connect incoming air supply.