ATD-31167
1/2" X 50' RETRACTABLE
AIR HOSE REEL
Instruction Manual
Specifications
• Spring driven, automatic rewind, with locking ratchet mechanism (eight locking positions per
revolution).
• Brass connectors on hose and reel.
• 50 Feet of ½” rubber Hose
• Incoming Air Connection: 1/2” NPT swivel
• Hose Connections: Male 1/2” NPT
• Maximum Pressure: 300PSI
• Maximum Air Flow: 35CFM
Read and understand entire manual before assembling or using hose reel. Failure to follow
instructions or warnings could result in personal injury and/or property damage.
Safety Rules
DO NOT EXCEED 300 PSI incoming air pressure (from compressor)
Wear impact-resistant eye protection that meets ANSI Spec.Z87.1 in work area at all times.
Do not release hose when rewinding. Hold hose end and allow hose to rewind slowly.
Never allow children to use hose reel. Keep children clear of work area at all times.
Warning
Do not over tighten reel. This may permanently damage the spring in the winding mechanism. Ideally, the
reel should be adjusted to wind up only as far as the desired height needed to reach the hose stop.
Exercise care when handling the hose reel during normal operation. This hose reel has a rotating spool
powered by springs under tension.
Mounting hardware and fasteners should be installed to maintain tightness under vibration and checked
periodically to ensure tightness.
Overhead installation mountings should be such that the reel is not supported by bolts in tension. A safety
chain or cable is strongly recommended to minimize damage and/or possible injury in the event of
mounting failure.