A&D GP-60K Building Set User Manual


 
70
Recalling the tare value (Quick selection mode)
The procedure below describes an easy way to recall the tare value to be used for weighing. When
the recalled tare value is to be changed, refer to “Storing the tare value”.
1 Set the “Data memory (data)” parameter to “5”.
2 Press the MODE key to enter the tare value recalling
mode. The tare value last selected with its tare
number appears. The display is as shown to the right,
with all the digits blinking.
3 Press the MODE key to select the value. Each time
the MODE key is pressed, the displayed value
changes as follows: t03 t04 t05 .... t20
t01.
4 Press the PRINT key to confirm the selection. The
balance returns to the weighing mode with the
selected tare value ready for use.
To cancel the selection, press the CAL key. The
balance returns to the weighing mode.
Note
When no operation is performed in step 4 (after a few
seconds of inactivity), the balance selects the value
currently displayed and returns to the weighing mode
automatically.
Canceling the tare value data
Cancel the tare value data as follows.
1 Remove everything from the weighing pan and press
the RE-ZERO key to cancel the tare value.