Filter
Top Products
Cheetah Wireless-3501C USB Adapter
4
2. Press the two lugs into the slots until they click into place.
3. To remove the clip, push in one of the lugs and pull the clip away from the WN3501C
body. The other lug should slip free.
Attaching the Magnets (Optional)
1. Peel the protective paper off the magnets and place the sticky side of the magnets
into the circular holes at the rear of the clip.
2. Press firmly.
Warning: Sticking magnets to a notebook screen will damage the screen.
Attaching the Velcro (Optional)
1. Peel the protective paper off the Velcro circles and firmly press the circles into the
circular holes at the rear of the clip.
2. Temporarily hold the WN3501C in the desired location and check the signal quality is
acceptable. Peel the protective paper off the Velcro strip and stick the strip in the
chosen location.
Attaching the USB Cable
1. Select an available USB port on the PC.
2. Carefully insert the USB cable’s Type-A plug (i.e., the flat plug) into the USB port and
press until it is firmly seated in the port. Insert the other end of the cable into the
WN3501C.
Warning: The plugs will only go into their respective slots one way. If the plugs do not
comfortably enter the slots, turn them around and try again.