4-3
EBU00056
Start switch “START”
The starter motor cranks the engine when this
switch is pushed.
CAUTION:
_
See starting instructions prior to starting
engine (see page 6-1 for details).
_
NOTE:
_
If the starter switch is pushed with the main
switch “ON” and the engine stop switch
“OFF”, the starter motor will be activated but
the engine will not start. To start the engine,
be sure to position the engine stop switch at
“RUN”.
_
EBU11560
Light switch “LIGHTS”
Set the switch to the “LO” position to turn on
the low beam and the taillight.
Set the switch to the “HI” position to turn on
the high beam and the taillight.
Set the switch to the “OFF” position to turn off
all of the lights.
CAUTION:
_
Do not use the headlights with the engine
turned off for more than thirty minutes.
The battery may discharge to the point
that the starter motor will not operate
properly. If this should happen, remove
the battery and recharge it.
_
U4XE16.book Page 3 Monday, March 24, 2003 3:14 PM
