A SERVICE OF

logo

10 11
Rotation
Clamp
ASSEMBLED VIEW
POINT TO
BACK OF RV
POINTER
MUST POINT
TO RED
SCREW ON
ROTATION
CLAMP
WHEN IN
TRAVEL
POSITION
CAUTION: After INITIAL
INSTALLATION, the
antenna should ROTATE

FROM TRAVEL POSITION.
The pointer on the
DIRECTIONAL HANDLE
should point towards
the RED SCREW on the
ROTATION CLAMP when
in TRAVEL POSITION.
1 Ceiling Plate
3 Directional
Handle Extension
4 Directional
Handle
ALIGN POINTER
WITH ANTENNA
TRAVEL POSITION
2 (4) #10 Phillips Flat
Head Screws
FIGURE 15
5 ELEVATING
CRANK HANDLE
(When installed,
extends 2-1/4”
from ceiling).
Snap Handle
into base
when not in use.
Tighten screw snugly
Threaded Tube
Elevating Shaft
Flat Washer
Nut for
threaded tube
CAUTION:
The antenna MUST BE IN THE
TRAVEL POSITION before
ALIGNING the Directional
Handle and Ceiling Plate.
Red Screw
11
EXPLODED PARTS VIEW
Antenna Head
Dish Frame
46 cm Reflector
White
(4) Flat Head Bolts
(White)
LB-1000: Standard
Single LNBF
E-Clip
Top Boom
Carriage Bolt
Pin 1-9/16long
Mount
Adapter
Rubber Bumper
Screw
Bushing
Bottom Boom
Flange Nut
1/4-20
Feed Arm
Roller
Hex Head Bolt 1/4-20 x 2.5”
Nylock Nut 1/4-20
(not shown)
Pivot Bracket
(Feed Arm)
Lift Link (2)
1-7/16”Long Pin (3)
E-Clip
Pin, 1/4 x 3.25long
E-clip for 1/4” Pin
Screw, 1/4-20 x 5”
Nylock Nut, 1/4-20
E-clip
Turret Top
Pivot Bracket
(Tubes)
INCLUDED BUT NOT SHOWN
LNBF Coax
RG
-6 (20’)
Antenna Head Coax
RG-59 (25’)
Travel Support Bracket
Screw # 10-24 x 3/4 (4)
Clamp (2)
4/22/02
Travel
Bracket
Cable Entry
Plate
Digital Elevation Unit
Interior
Wall Plate
Display Unit