Application 2 Watlow MINICHEF 2000 ■ 21
Change Menus
1. With the controller in idle, select the menu you want to run by performing the pro-
cedure under “Select a Menu” earlier in this section.
2. Press the Start/Stop key.
Based on its programming, the unit will run the menu in one of the ways described
earlier.
Door Opening
When you open the oven door (uses Event Output 1 for switch closure. Switch closure
indicates the door is open) the unit will act as described below.
During the cooking sequence: time is paused— [`Door] will appear on the display. The
heat and fan output signal will shut off.
During the preheat or hold sequence: [`Door} will appear on the display. The heat and
fan output signal will shut off.
When you close the door the unit will operate normally.
Event Outputs
While running a menu when the Configuration Mode [EtyPE] / [FAn``] is set to
[``2]:
When Low fan speed is on, Event Output 1 is on.
When High fan speed is on, Event Output 2 is on.
While running a menu when the Configuration Mode [EtyPE] / [FAn``] is set to
[``1]:
When the fan is on, Event Output 1 is on.
ç
WARNING: Starting or initiating a menu can cause or initiate fan motion. Appropriate reasonable care should be
taken to prevent personal injury or machine damage as a result of operator initiated or unexpected fan motion.
Temperature Alarms
The controller will alert you to temperature alarm conditions if they occur. If an alarm
occurs, take action as determined by your supervisor. See the Appendix in the Hardware
& Software Setup Guide for a Troubleshooting Chart and a summary of temperature
alarms.
Errors
The controller will alert you to errors if they occur. Errors are critical problems that
shut down the unit. If an error occurs, an error message will appear on the display. You
should switch off the power and call for service.
See the Appendix in the Hardware & Software Setup Guide for a Troubleshooting Chart
and a summary of errors.
