Tripp Lite SU8000RT4U Manual

A SERVICE OF

next previous

8

3a

3b

External Battery Connection

YourUPScomeswitharobustinternalbatterysystem;externalbatteriesareneededonly

to extend runtime. Adding external batteries will increase recharge time as well as

runtime.TheillustrationshowsthelocationofyourUPS'sExternalBatteryConnector,

whereyouwillinsertthebatterypackcable

3a

.Completeinstallationinstructionsfor

yourbatterypackappearinthebatterypackowner'smanual.Makesurethatcablesare

fullyinsertedintotheirconnectors.Smallsparksmayresultduringbatteryconnection;

thisisnormal.DonotconnectordisconnectbatterypackswhentheUPSisrunningon

batterypower.

NOTE: Select models feature a Battery Charge Level Switch

3b

. If you connect any

external batteries to these models, set the Battery Charge Level Switch (see diagram)

to the right (labeled “EXTERNAL BATTERIES”). This will increase your UPS's

charger output so the additional batteries charge faster.

CAUTION! DO NOT set the Battery Charge Level Switch to the right (labeled

“EXTERNAL BATTERIES”) without an external battery connected. There is a risk

of damaging the UPS's internal battery system.

Internal SNMP/WEB Card Insertion

Removetheslot'scovertoinstallanoptionalinternalSNMP/Webaccessorycard(Model:

SNMPWEBCARD)toenableremoteUPSmonitoringandcontrolviaSNMP,Webor

telnet.ContactTrippLiteCustomerSupportat(773)869-1234formoreinformation,

includingalistofavailableSNMP,networkmanagementandconnectivityproducts.

3

4

4

SU6000RT4U

Shown (Rear View)

Optional Connection (continued)

201102170 932611.indd 8 3/30/2011 10:22:13 AM