38
1. For ease of installation, extend
LATCH to its maximum length
and remove from storage bars.
2. Position base in vehicle seat as
shown.
3. Make sure LATCH is through
vehicle/LATCH belt path normally
used for vehicle seat belt.
➋
.
Belt must lay flat and not be twisted.
4. Hook Connectors to vehicle lower
anchors. Pull firmly on Connectors to
be sure they are attached ➌.
5. Tighten LATCH by pushing down
hard on base and pulling the
adjustment belt ➍.
6. NEVER put two LATCH connectors
on one vehicle LATCH anchor unless
specifically allowed by the vehicle
manufacturer
➎
.
7. Test infant restraint for secure
installation as described in infant
restraint “ Final Safety Check” page.41.
8. Check that the LATCH stays tight and does not
slip from the tightened position. If it does not stay
tight, try another seating position or contact Teutonia
at 1-877-TEUTONIA (1-877-838-8664).
7.3 Using LATCH to install Base
➋
➍
➎
➌
