PP10 User Manual ◄ 11
TOOL PROTECTION & CARE
• Make sure all couplers are wiped clean before con-
nection. Use only lint-free cloths.
• The hydraulic circuit control valve must be in the
OFF position when coupling or uncoupling hydrau-
lic tools. Failure to do so may result in damage to
the quick couplers and cause overheating of the hy-
draulic system.
• Always store the tool in a clean dry space, safe from
damage or pilferage.
• Always replace hoses, couplings and other parts
with replacement parts recommended by Stanley
Hydraulic Tools. Supply hoses to the intensier must
have a minimum working pressure rating of 2500
psi/175 bar.
• All hoses must have an oil resistant inner surface
and an abrasion resistant outer surface. Whenever
near electrical conductors, use clean hoses labeled
and certied non-conductive.
• Always keep critical tool markings, such as warning
stickers and tags legible.
• Do not exceed the rated limits or use the tool for ap-
plications beyond its design capacity.
• Tool repair should be performed by experienced
personnel only.
• Never connect or disconnect couplers or port con-
nections with hydraulic pressure in the hose.
• Make certain that the recommended relief valves
are installed in the pressure side of the system.
• Always check high-pressure couplers for leaks and
damage before operating the system at maximum
rated pressure.
• Check fastener tightness often and before each use
daily.
In addition to the Safety Precautions found in
this manual, observe the following for equipment
protection and care.
