© 2003 Shure Incorporated DFR22 Software Guide 75
Ducker
Release
This controls the amount of time it takes the processor to return the ducked signals to their previ-
ous level once the hold time has passed. You can change this value by clicking on the spin but-
tons or by typing in a specific value. The range of available values is from 1 ms to 10,000 ms.
Default
Click this button to reset the processor to its system default settings.
Bypass
Paging Channels
Check the box next to each output to which you want to route the paging signal.
This is the same as using the signal diagram or matrix mixer to route the signal
from this input to the outputs. Any other signal routed to the selected output mix point(s) will be attenuated
by the paging signal.
Link Indicator
This displays the link status of the processor. Any setting you change in a linked processor will change for all
other processors in the same link group. For a complete explanation of linking and link groups, see the
Linking section on page 24.
Bypass active
Click to pass signal through without altering it. When bypass
is active, the button appears lighted in red. The default set-
ting is inactive.
Bypass inactive
Processor Linked
Processor Not Linked
