12
POWER ON AND OFF
The power switch is located on the left side of the machine.
POWER ON
Turn the power switch to the "ON"
position
It will take about 45
seconds for the machine
to warm up.
While the machine is
warming up, the POWER
SAVE indicator will blink.
(The POWER SAVE
indicator will go off when
the machine is ready to
copy.)
However, you can make desired settings and press
the [START] key ( ) during warm-up. Copying will
start after warm-up.
POWER OFF
Make sure that the machine is not in
operation and then turn the power switch
to the "OFF" position.
If the power switch is
turned off while the
machine is in operation,
a misfeed may occur and
the job that was in
progress will be
canceled.
Check the following to make sure the machine is not in
operation:
• Is the START indicator lit? (Initial state)
• Is the POWER SAVE indicator lit? ("Preheat mode"
or "Auto power shut-off" mode) (p.00)
Power Save Modes
Preheat mode
When the machine enters the "Preheat mode", the POWER SAVE indicator will light up and other indicators will
remain on or off as before. In this condition, the fuser in the machine is maintained at a lower heat level, thereby
saving power. To cancel "Preheat mode", press any key on the operation panel. "Preheat mode" also turns off
automatically when a print job is received or when an original is placed for copying or scanning.
Auto power shut-off mode
If the "Auto power shut-off" mode is enabled, the machine will automatically turn off the power once a programmed
length of time has elapsed without any machine operation after the last copy of a run is made or the power is first
turned on. (Based the guidelines of the international Energy Star program.) To cancel "Auto power shut-off", press
the [START] key ( ). "Auto power shut-off" also turns off automatically when a print job is received or when
scanning is begun from a computer.
• "Auto clear" is initially set to return the copy settings to the initial settings when the [CLEAR ALL] key ( ) is
pressed, and after one minute elapses after a copy job is finished. When "Auto clear" operates, all previous
settings are cleared. The setting for "Auto clear" can be changed in the user programs. (p.00)
• The machine is initially set to automatically enter power save mode if not used for copying, printing, or scanning
for a preset period of time. This setting can be changed in the user programs. (p.00)
The machine has two power save modes to reduce overall power consumption thereby
reducing the cost of operation. In addition, these modes conserve natural resources and help
reduce environmental pollution. The two power save modes are preheat mode and auto power
shut-off mode.
The preheat activation time and the "Auto power shut-off time" can be changed using user programs. It is
suggested that you set times that are appropriate for your usage of the machine. (p.00)
Note
Note
Initial settings
The machine assumes the initial settings when it is first turned on, when the [CLEAR ALL] key ( ) is pressed,
and approximately one minute after the last copy is made in any mode.
Copy ratio
: 100%,
Exposure
: Automatic
Copy quantity
: 0, All special copier modes: Off
Auto paper selection
: On,
Paper feed station
: The tray selected in the "Default tray setting" in the user programs.
