9
3/8" x 1"
HEX BOLT
3/8" x 3"
HEX BOLT
3/8" NYLOCK NUT
FIGURE 14
24. Assemble the engine to the tongue using two 3/8" x 3"
hex bolts in the rear holes, two 3/8" x 1" hex bolts in the
front holes and four 3/8" nylock nuts. See gure 14.
HINT: Use caution when assembling engine to tongue. Have
another person assist you if you are having difculty.
HINT: For easier assembly, support the tongue with a block
of wood.
25. Place the hose hanger rod down into the hose hanger
bracket on the impeller housing assembly. See gure
15.
FIGURE 15
19. Flip the cart over so that it rests on its wheels.
20. Assemble the front tongue on top of the rear tongue
using three 3/8" x 3" hex bolts and 3/8" hex lock nuts.
See gure 12.
HINT: For easier assembly, support the rear tongue with
a block of wood.
21. Assemble the hitch pin to the hitch bracket and tongue,
securing it with the 1/8" hair cotter pin. See gure 12.
TONGUE
(FRONT)
3/8" x 3"
HEX BOLT
BLOCK
3/8" HEX
LOCK NUT
1/8" HAIR
COTTER PIN
HITCH PIN
FIGURE 12
NYLON WASHER
WING NUT
5/16" X 3/4"
HEX BOLT
(SELF TAP)
FIGURE 13
22. Attach the plastic elbow to the top of the engine housing
using four 5/16" x 3/4" hex bolts (self tapping) and nylon
washers. See gure 13.
HINT: Push in on hex bolts as you tighten to form threads.
23. Connect the hose adapter to the engine housing by
fastening three wing nuts to the pre-assembled bolts
in the engine housing. See gure 13.
