Section 5: Printer Configuration
SATO M10e Service Manual PN 9001113A Page 5-13
IGNORE CR/LF
YES NO
This selection tells the printer to strip out all carriage return/line feed pairs (CR/
LF) from the data stream, including graphics and 2D bar codes. It is used
primarily to maintain compatibility with earlier models of SATO printers.
1. Use the CURSOR keys to step the cursor to either the YES or NO option.
2. Press the ENTER key to select the option and advance to the next display.
CHARACTER PITCH
PROP FIXED
This selection allows the default character pitch to either be set for fixed
character spacing or proportional character spacing.
1. Use the CURSOR keys to step the cursor to the desired option.
2. Press the ENTER key to select the option and advance to the next display.
ADVANCED MODE To exit the Advanced mode, power the printer off and then back on.
CARD MODE
The Card Mode is entered from the Advanced Mode display. The Card Mode allows the operator to
manage the Expanded Memory (PCMCIA Card or Internal Expanded Flash ROM).
LCD DISPLAY DEFINITION
V 05.00.03.00
INITIALIZING
Displays the firmware during the initialization.
ADVANCED MODE The Card Mode is entered from the Advanced Mode display by pressing the
right CURSOR key (>>) once.
CARD MODE The Card Mode display indicates that the printer is in the Card Mode. To
advance to the first selection, press the ENTER key.
MEM SELECT (CC1)
CARD MEMORY
This selection determines which type of optional expanded memory will be
addressed as “CC1" in the command streams. The CARD selection specifies
the optional PCMCIA card as CC1 and the optional Expanded Flash ROM as
CC2. The Memory selection specifies the optional Expanded Flash ROM as
CC1 and the optional PCMCIA card as CC2.
1. Use the CURSOR keys to step the cursor to the desired option.
2. Press the ENTER key to select the option and advance to the next display.
CARD->MEMORYCOPY
TRUETYPEFONT Y/N
This selection allows TrueType fonts to be copied from the PCMCIA Memory
card installed in the Memory Card slot.
1. Use the CURSOR keys to step the cursor to desired option. If Yes is
selected, the printer will enter the Card Copy mode. If No is selected, the
display will advance to the Card to Memory SATO Font Copy mode.
COPY START
YES NO
2. Confirm the selection by stepping the cursor to the Yes option. If No is
selected, the display will return to the previous selection.
TRUETYPEFONTCOPY
COPYING
3. Press the ENTER key to select the option. If Yes was selected the copy
process will begin.
TRUETYPE FONTCOPY
COMPLETED
4. Once the copy process is complete, press the ENTER key to step the
display.
LCD DISPLAY DEFINITION
