GB
19
GB
18
Auto Channel Search will automatically seek and store all active
channels in your area.
1 Open “SETUP MENU”
Press the SETUP button.
2 Select “VCR & Channel Setup”
Using the up/down, move the selection arrow to “VCR & Channel
Setup,” then push right to select.
3 Select “Channel Setup”
Move the selection arrow to “Channel Setup,” then push right to
select.
4 Run “Auto Channel Search”
Move the selection arrow to “Auto Channel Search,” then push right
to select.
• The DVD-VCR will automatically search for all available
channels in the selected Tuner Band. This procedure may take
a few minutes to complete.
• When finished, the lowest channel found will be displayed.
Auto Channel Search
1
Tuner Band Setting
This feature allows you to manually set the DVD-VCR’s tuner band
to Antenna or Cable, whichever you connected to the Antenna In
jack during initial setup.
• Use this setting only if Auto Setup detected the incorrect tuner
band, i.e. channels are coming in on the wrong channel numbers.
1 Open “SETUP MENU”
Press the SETUP button.
2 Select “VCR & Channel Setup”
Using the up/down, move the selection arrow to “VCR & Channel
Setup,” then push right to select.
3 Select “Channel Setup”
Move the selection arrow to “Channel Setup,” then push right to
select.
4 Select “Tuner Band”
Move the selection arrow to “Tuner Band,” then push right to select
from the following options:
• Auto - Automatically detects the Tuner Band.
• Antenna - Indicates that the DVD-VCR is connected to an indoor
or outdoor VHF/UHF antenna.
• Cable - Indicates that the DVD-VCR is connected to either
Community Antenna Television (i.e., cable TV without a cable
box).
1
01616A DVD-V8000/TWN-Eng2 8/27/56 8:57 AM Page 18
