![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/d/21/d219d286-8877-4d44-8fc7-96c5e51b75fa/d219d286-8877-4d44-8fc7-96c5e51b75fa-bga.png)
ENG-9
Plug & Auto Set up
Tuning Your Television for the
DVD-VCR
Your DVD-VCR will automatically set itself up when it
is plugged into the mains for the first time. TV stations
will be stored in memory. The process takes a few
minutes. Your DVD-VCR will then be ready for use.
1 Connect the coaxial cable as indicated on page 7.
(Connecting Your DVD-VCR to the TV Using the
Coaxial Cable)
2 Plug the DVD-VCR into the mains.
Result:
The Language Set menu is displayed.
3 Select the required language by pressing the
or
❷
buttons.
4 Press OK to store the language selected.
Result:
A message appears.
5 Press OK to start the auto scanning.
◆
The number of stations automatically stored by
theVCR depends on the number of stations that
it has found.
You must tune your television for the DVD-VCR only if
you are not using a RCA cable
➢
To view pictures from your DVD-VCR when a
RCA cable is used, the television must be set to
the audio/video mode (AV).
1 Switch on the television.
2 Switch on the DVD-VCR by pressing STANDBY/ON
on the front of the DVD-VCR or STANDBY/ON on
the remote control.
3 Select a programme position on the television to be
reserved for use with your DVD-VCR.
4 Insert the video cassette in the DVD-VCR. Check
that the DVD-VCR starts reading the cassette; if
not, press
❿
II
button.
5 Start a scan on your television or set the television
to UHF channel 36.
6 Fine tune the television until the pictures and sound
are obtained clearly.
7 If you cannot find the pictures and sound, or there
is interference from nearby channels, it may be
necessary to change the setting of the DVD-VCR
output channel (see Setting the DVD-VCR Output
Channel on page 14 and Problems and Solutions
on page 44).
8 When the picture and sound are perfectly clear,
store this channel at the desired programme
position on the television.
Result: That programme is now reserved for use
with your DVD-VCR.
Auto setup
Please wait
00 %
Clock Set
12 : 00 1/JAN 2004
THU
Time Date Year
➢
Auto preset can be performed by pressing
■
on
the VCR continuously for 5 seconds or more with
no tape inserted.
00413B DVD-V540/XSG-ENG 5/6/04 12:07 PM Page 9