![](https://pdfstore-manualsonline.prod.a.ki/pdfasset/5/e2/5e286113-a280-4c20-be79-49d2b64fa374/5e286113-a280-4c20-be79-49d2b64fa374-bg18.png)
24
TROUBLESHOOTING
If you experience problems with your
TAD, check the possible causes in this
section. If you still have problems, con-
tact your local Radio Shack store for as-
sistance.
The incomin
messa
e is incom-
plete.
• Be sure the memory is not full.
• The caller’s message was longer
than 60 seconds.
• The caller was silent for over 8 sec-
onds.
The incomin
messa
e is unclear.
•Be sure
VOLUME
is turned up.
The TAD does not answer after two
or four rin
s.
• Be sure the TAD is set to answer
calls.
Lo
flashes on the displa
• The backup battery is weak.
Replace the battery (see “Installing
the Backup Battery”).
You cannot record an incomin
mes-
sa
e.
• Be sure the TAD is set to answer
calls.
• Make sure the memory is not full.
The TAD does not respond to the re-
mote operation securit
code.
• Make sure the phone you used to
dial the TAD is a touch-tone phone.
(If it is not, you can use a pocket
tone dialer to enter the code and
commands.)
• Make sure the remote operation
security code you entered is cor-
rect.
There is line interference, or
our
touch-tone si
nals are not lon
and
clear enou
h for the TAD to reco
-
nize.
• Re-enter your security code and
press each button for 2 seconds.
No messa
es appear on the displa
.
• This could be caused by a power
failure. Reset the TAD by removing
the AC adapter and the battery
from the TAD, then reinstalling
them.
43-744.fm Page 24 Friday, August 13, 1999 2:10 PM