CID98LS_qwest Manual 11/8/00 8:17 AM Page 6
INSTALLATION WITH A TELEPHONE
ANSWERING MACHINE
CONNECTING DIRECTLY TO A WALL JACK
A telephone is not required for the operation of the Call Waiting ID unit.
Simply plug one end of the included line cord into an empty telephone
wall jack and the other end into the jack marked “TEL LINE” on the back
of the Call Waiting ID unit.
Note: You will not be able to receive Call Waiting data when the unit is
connected directly to a wall jack and not connected to a telephone.
8 9
TROUBLESHOOTING TIPS
Caller ID information does not display when the phone rings.
•
Wait until the phone rings twice before answering.
•
Make sure the line cord from the wall is inserted in the jack marked
“TEL LINE” and that the line cord from the telephone is inserted in the
jack marked “PHONE”.
•
Make sure your Caller Waiting ID service has been activated. Call the
Qwest Services Center at 1-800-770-2513.
Information does not display when a Call Waiting
call comes in.
•
Check that all telephone line cords are correctly installed.
•
You must subscribe to the Call Waiting ID service for this feature to
work. Call the Qwest Services Center at 1-800-770-2513.
There is no dial tone on the telephone attached to the
Call Waiting ID unit.
•
Check all cords to make sure that all connections are secure.
The LCD display is dim.
•
Adjust the contrast control using the DELETE and REVIEW keys to darken
the display. See “DISPLAY CONTRAST” on Page 6 of this manual for
instructions.
OUTLETID UNITANSWERING MACHINEPHONE JACK
TEL LINEPHONE
