RTM-C
Installation Instructions Page 5
Attaching the RTM-C to the Suspension Pole
Once the mounting configuration has been determined and installed, the RTM-C may be attached.
NOTE
: Depending on the installation configuration, a 1-1/2” NPT must be installed prior to installing
the RTM-C.
NOTE
: It is recommended that two people install the RTM-C. While one person attaches the RTM-C onto
the suspension pipe, the other person must hold the ladder.
1. Place the RTM-C coupler onto the threaded end
of the suspension pole. Thread the coupler onto
the threaded pipe tighten at least seven (7)
complete turns.
2. After the RTM-C has been threaded onto the
1-1/2” NPT, tighten the M6 x 10mm
set screw using a M3 Allen wrench (supplied).
3. Use the cable management holes, along with
the cable ties, to secure and hide any loose
cables and wires.
Threaded Pipe
RTM-C
M3 Allen
Wrench
Cable
Management
Holes
M6 x 10mm Set
Screw
Cable Management
Holes
