4 Polk Audio Custom
Install Pr
oduct: Model Number
SPECIFICA
TIONS
LCi-RTSFX
Installed W
eight: 10.75 lbs. (4.88kg)
(not including Stud-Lock Mounting System
™
)
W
eb Addr
ess:
For more information on the LCi-RTSFX, log onto
www.polkaudio.com/downloads/manuals/
home/LCi-R
TSFX_manual.pdf
PERFORMANCE
POWER HANDLING (WATTS/CHANNEL) 10-250W CONTINUOUS
IMPEDANCE (NOMINAL) 4 OHMS
FREQUENCY RESPONSE (OVERALL)
50HZ–27KHZ
THX SPEC 80HZ-26KHZ
EFFICIENCY (2.83V@1M) 88dB
SPEAKER WEIGHT (INSTALLED) 10.75 LBS (4.88KG)
DRIVER COMPLEMENT
MIDBASS 2-5 1/4" (13.34CM)
AERATED POLYPROPYLENE
DYNAMIC BALANCE
™
DRIVERS
TWEETER
1-1" (2.54CM)
RING RADIATOR TWEETER
CONNECTIONS
SPEAKER WIRE
MAXIMUM WIRE SIZE ACCOMMODATED 12 AWG
MINIMUM RECOMMENDED
18 A
WG
INPUT CONNECTORS HEAVY-DUTY SPRING LOADED
PUSH TERMINALS
Stud-Lock Mounting System
™
(RTSFX only)
Installation:
See the instructions included with each Stud-
Lock Mounting System
™
.
Important Note: For new construction: If you are using a pre-
construction bracket, always install it first before installing the
Stud-Lock Mounting System
™
.
If you are installing a pre-construction bracket (PBC) and a Stud-
Lock Mounting System (STL105) together, be aware that the
speaker’s enclosure can catch on the edge of the pre-construc-
tion bracket. Push the bottom of the loudspeaker enclosure up
and over The protruding edge of the pre-construction bracket.
This will fully seat The loudspeaker in the wall.
Important Notes:
If you are using a Pre-Construction Bracket, always
install the Pre-Construction Bracket before installing the
Stud-Lock Mounting System
™
. Be sure to clear the Pre-
Construction Bracket wire guide when installing the
Stud-Lock Mounting System
™
.
STL105
Center the bracket vertically in
the cutout. The lip of the Stud-
L
ock bracket and the cutout
s
hould align.
Drywall shown cut away for clarity.
