A SERVICE OF

logo

Open as PDF
next previous
User’s Manual of WSD-800 / WGSD-910/WGSD-1022C
-100-
Figure 7-4 Assign Port-1 to be VLAN 2 and VLAN 3 member.
7. After the down the Port 1 VLAN configuration, press “close” to back to the 802.1Q VLAN main screen. And
check if the setting be applied to Port 1 at the “Egress Policy” column. The screen in Figure 7-5 appears.
Figure 7-5 Port 1 VLA N status
8. Assign the VLAN 2 and VLAN 3 group member. At this case, Port 2 had been assigned to as VLAN 2 group
member and Port 3 be assigned to as VLAN 3 group member.
9. Repeat step 2 to step 7, expect that :
• Configure the Port 2 with PVID=2, Port 3 with PVID=3.
• The link type of both Port-2 and Port 3 are “Always Untag”.
• And both Port 2 and Port 3 are VLAN 1 members.
10. After properly configure the 802.1Q VLAN per port setting, it should be as the screen in Figure 7-6 appears.