A SERVICE OF

logo

17
When installing the camera on a ceiling or a wall, there are 3 methods as specified below.
• Usingatwo-gangjunctionbox(
pages 18 and 19)
• Installingthecameradirectlyontheceilingorwall
SW458M
( page 19)
• Usingthesuppliedmountbracket
SW458
( pages 20 to 23)
IMPORTANT:
• Procure4screws(M4) to securethecamera attachment (accessory)or the mountbracket
(accessory)
SW458
to a ceiling or a wall according to the material of the installation area. Do
not use wood screws and nails.
For mounting a camera on a concrete ceiling, use an anchor bolt (M4) or an AY plug bolt (M4)
for securing. (Recommended tightening torque M4: 1.6 N·m {1.18 lbf·ft})
• Mountthecameraattachment(accessory)inconsiderationofthecameraangleinaccordance
with the instructions (
pages 18 and 19).
• Requiredpull-outcapacityofasinglescrew/boltis196N{44lbf}ormore.
• Ifaceilingboardsuchasplasterboardistooweaktosupportthetotalweight,theareashall
be sufficiently reinforced.
The mounting conditions of the camera are described as follows:
Installation
place
Appropriate mount
bracket
Recommended
screw
Number of
screw
Minimum pull-out
strength (per 1 pc.)
Ceiling/wall Two-gang junction box M4 4 pcs. 196 N {44 lbf}
SW458M
Ceiling/wall
(Direct mounting) M4 4 pcs. 196 N {44 lbf}
SW458
Ceiling/wall*
Mount bracket (accessory) M4 4 pcs. 196 N {44 lbf}
* The conditions for securing the mount bracket to a ceiling or a wall are described here.
Preparations