[E-mail notification]
Select “On” or “Off” to determine whether or not to provide notification by E-mail according to the settings for
the “Alarm” and “Diag.” checkboxes of “Destination of notification” below.
– When an alarm is detected (“Alarm”)
:
– When a notification of the remaining capacity of the SD memory card has been provided (“Diag.”)
– When the SD memory card has become full (“Diag.”)
– When the SD memory card cannot be recognized (“Diag.”)
• Default: Off
[Alarm image attachment]
Select “On” or “Off” to determine whether or not to attach an image to the E-mail to be sent when an alarm is
detected.
• Default: Off
Note
• The settings for “Image capture size” of the “Alarm image” section on the [Alarm] tab (®page 137) will
be applied to the size of the image to be attached.
Destination of notification
[Address 1] - [Address 4]
Enter the destination E-mail address. Up to 4 destination E-mail addresses can be registered.
• [Alarm] checkbox: When the checkbox is selected, the E-mail notification will be performed upon an alarm
occurrence.
• [Diag.] checkbox
: When the checkbox is selected, the mail notification will
be provided in the following cases.
– When notification of the remaining capacity of the SD memory card has been provided
– When the SD memory card has become full
– When the SD memory card cannot be recognized
• [Destination E-mail address]: Enter the destination E-mail address.
– Available number of characters: 3 - 128 characters
– Available characters: Alphanumeric characters, the at sign (@), the period (.), the underscore (_),
and the hyphen (-).
– Default: None (blank)
To delete the registered address, click the [Delete] button respective to the desired address.
[E-mail subject]
Enter the E-mail subject.
• Available number of characters: 0 - 50 characters
• Default: None (blank)
[E-mail body]
Enter the E-mail body.
• Available number of characters: 0 - 200 characters
• Default: None (blank)
146 Operating Instructions
13 Configure the alarm settings [Alarm]
