+
+
-
-
7
Accessories Supply
Accessories
Clamper × 1 Eyebolt cap × 1
Blind sheet × 1 Allen wrench
Eyebolt × 1
(M12)
Ferrite core × 2
Noise cut fi lter
Batteries for
the Remote
Control
Transmitter
(R6(UM3) Size
× 2)
Power supply
cord
Fixing band
× 2
Remote Control
Transmitter
EUR7636090R
Operating
Instruction
book
Check that you have the accessories and items shown
Remote Control Batteries
Use the clamper
when connecting a
LAN cable.
(see page 59)
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline
batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5.
Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
CD-ROM
(Operating
instructions)
Requires two R6 batteries.
1. Pull and hold the hook, then open
the battery cover.
2. Insert batteries - note correct
polarity ( + and -).
3. Replace the cover.
“R6 (UM3)” size
Use the Ferrite cores and Noise cut fi lter to
comply with the EMC standard. (see page
59)
