26
Remote control setting
Remote Control Operation is possible for the Panasonic VCR’s and DVD’s equipment.
After completion of setting, execute the various operations after pressing the VCR / DVD selection switch.
Switch to select VCR or DVD.
While pressing the VCR / DVD Power button, press the manufacturer code
(enter the two digit code), and press the VCR / DVD Stop button.
Notes:
• After setting, execute operation confi rmation. If there is no operation, set a different code.
• The respective VCR / DVD code is cancelled when battery has been exchanged. Please set it again.
• Depending on the model, operation may not be possible.
• In some cases, new products may not be operative.
VCR DVD
TV
OK
1 2 3
4 6
7 8 9
0
5
1 2 3
4 5 6
7 8 9
0
Stereo / Bilingual Sound Selection
When you receive the stereo / bilingual sound system, sound output modes can be selected by pressing
the Stereo / Bilingual Sound Selection button.
Notes:
• If the stereo signal is poor or the receiving conditions are not optimum or if STEREO:MONO automatic switching
occurs, it is recommended you switch from STEREO to MONO.
• Even when the contents of the receiving signal undergo changes, selection mode is kept intact.
• When the receiving conditions deteriorate, listening will be easier if the mode is set to the MONO position, using the
stereo / bilingual sound selection button.
• DUAL, also known as DUAL MONO or as BILINGUAL is not currently transmitted in some countries.
VCR
Manufacturer Code
Panasonic/ National 10,11,12,13
DVD
Manufacturer Code
Panasonic 70, 71
Audio Signal STEREO
MAIN
I
SUB
II
MONO
Mode Indicator
I II
NICAM .......Used in New Zealand, Singapore, Hong Kong etc.
Type of broadcast
Regular broadcast
(Standard Audio)
Regular + NICAM MONO
I
(MAIN
I
)
NICAM STEREO
NICAM DUAL MONO
(MAIN
I
/ SUB
II
)
Mode Indicator
No Indicator
I
I
II
A2(German) .......Used in Australia, Malaysia etc.
Type of broadcast
Regular broadcast
(Standard Audio)
BILINGUAL or DUAL MONO:
MAIN
I
/ SUB
II
STEREO
Mode Indicator
No Indicator
III
