Care and Replacement
Cleaning the projector
Before cleaning the projector
J
Switch off
MAIN POWER in proper way and disconnect the power plug from the wall outlet.
Unplug all the cables from the projector.
Cleaning the outer surface of the projector
J
Wipe off dirt and dust gently with a soft cloth.
If it is difcult to remove the dirt, soak a cloth in water, wring the cloth well and then wipe the projector. Dry off the
projector with dry cloth.
Do not use petroleum benzine, thinner, any alcoholic solvent, kitchen detergents or chemical clothes. Failure to
observe these may result in altered or damaged surface of the projector.
Cleaning the lens surface
J
Wipe off dirt and dust gently with a lint-free cloth.
Make sure no dirt or dust remains on the surface of the lens. It will be enlarged and projected onto the screen.
Cleaning the air lter
J
If the air lter is excessively dirty, the internal temperature of the projector increases and may cause
malfunction. Clean the air lter regularly every 100 hours of usage.
Place a nger at the bottom of the air lter.1.
Slightly push up and pull out the air lter to remove.2.
Vacuum dirt and dust from the air lter.3.
Do not wash the air lter.
Place and slightly slide in the air lter in the air intake port to attach.4.
Make sure the air lter clicks into the place.
NOTE:
Do not use the projector without attaching the air lter. •
J
Replacing the air lter
The air lter should be replaced when cleaning is ineffective and when replacing the lamp unit. A replacement
air lter (TXFKN01VKF5) is provided with a replacement lamp unit, ET-LAE4000. Contact an Authorized
Service Center for the optional air lter.
